SolutionsHousehold & chemical
Glue bottles
Glue bottles for stationery, furniture and woodworking, with a flash-free injection-molded neck and a perfect cap fit.
Production know-how
Glue bottles: how we make them
- The neck is injection molded and the body blown on the same machine at different stations, so the neck is smooth and free of flash when the shot weight is set correctly.
- There is only one hot-runner gate mark on the bottom; the surface is smooth and production runs without stops.
What to send us
- Bottle drawing, sample or photo
- Volume and material
- Neck finish and closure
- Target output per hour
Three-station injection blow molding
One machine, three stations, a finished bottle
- Station 1 · 0°
Injection
The preform is injection molded on a core rod – the neck and thread of the glue bottles are finished here and never change again.
- Station 2 · 120°
Blowing
The table turns 120° and air through the core rod blows the warm preform into the bottle mold. No parison, no pinch-off, no flash.
- Station 3 · 240°
Stripping
Another 120° and the finished bottle is stripped off the rod, ready to pack – no trimming and no scrap, with all three stations working at once.
Suggested machines
Typical machines for household & chemical
A starting point – the right model depends on your bottle volume, shot weight and cavity count.











